Jack Daniel's Grilled Steak Recipe | The Perfect Grilled Steak (2024)

FAQs

How to make a perfect steak on the grill? ›

Place the steaks on the grill and cook until golden brown and slightly charred, 4 to 5 minutes. Turn the steaks over and continue to grill 3 to 5 minutes for medium-rare (an internal temperature of 135 degrees F), 5 to 7 minutes for medium (140 degrees F) or 8 to 10 minutes for medium-well (150 degrees F).

As a rule of thumb, when cooking steaks that are 1-1/2 inch thick, you want to go by the 3-4 rule. That is, three minutes per side on direct heat, then four minutes per side on indirect heat. That will get your steaks to a beautiful pink medium-rare.

INGREDIENTS: SEA SALT, DEHYDRATED GARLIC, ONION AND BELL PEPPER AND SPICE.

Brush or place the butter directly on top of the meat, not on the grill. Limit the grilling time of the butter. Grill your meats first without the butter, then apply butter when the meat is approximately 10 degrees away from your target temperature.

Before it hits the Grill

Lightly oil the steak on both sides to prevent it from sticking to the grill. It's best to add oil directly to the steak and not to the grill as oil will burn quickly on the grill causing excess smoke and flare-ups.

We typically recommend flipping your steak just once on the grill because it's not getting direct heat on one side like it would on a pan. Instead, the steak is up a few inches from the flame, allowing the heat to circulate a bit more.

For thicker cuts, you want to close the lid to keep the temperature high and even. Large steaks, chicken, and roasts have much more depth for the heat to penetrate, and closing the lid will give the heat time to sink in and cook the meat through in much the same way an oven does.

That's right: Go ahead and plop the ribeye on your cutting board and walk away for—surprise—five minutes (give or take). We know it's super tempting to dive right in, but you should resist slicing your steak for about five to ten minutes after it comes off the heat. The result? A juicier, more flavorful meal.

Bourbon must be matured in new, charred-oak barrels. Jack too only uses its barrels one-time. Because it's with the first fill that a barrel imparts its most intense flavor and character.

Jack Daniel chose a well-considered recipe of 80% corn, 12% barley and 8% rye that we still use today. Using only No. 1 quality grade corn gives the mash an inviting sweetness. An ample amount of rye rounds out the sweetness with robust notes of pepper and spice.

What do you season steak with before grilling? ›

A generous helping of kosher salt and coarse, freshly ground black pepper is all you need to complement the naturally juicy flavors of a good steak, but some people also like to add a little rosemary, cayenne powder, garlic powder, or garlic cloves to the mix.

Brush your cooking grates clean and adjust your grill for direct, high heat. The best temperature for steaks is 450°F to 500°F. 4. Put your steaks on the grill, close the lid, and set your timer for 2 to 3 minutes, depending on the thickness of your steak.

3. Season the Steak: Steaks don't need much to make them great. Just before grilling, brush them lightly on both sides with olive oil and sprinkle with salt and pepper. If you want to get fancy, you can add spices like chili powder, paprika, or garlic powder to the rub.

The best grill temperature to grill a steak is high heat (450-550 degrees F.). To prepare steaks for the grill you will need to: Pat them dry: this helps the steaks get a better sear on them.